LED illumination set |
Connect port |
LED
illumination set
To provide high stability, long life,capable of providing
an appropriate light sources, so that more accurate
measurement.
Ring light up to 16 parttions can be split,Every partition
can be individually controlled. Active, inactive and
adjust the brightness by program......
more |
|
Power SW and lamp |
Connect port |
Measurement dedicated controller
This measurement dedicated controller is our independence develops. It's provide up four servo motor control....... more
|
|
Joystick box
|
Joystick box
This joystick box is our independence develops. It's provide 3-axis movement control and movement speed
adjustment...... more
|
|
4 port digital tools input |
to PC's RS232 & USB |
Digi-Std4
data processor / ASCII to RS232 or USB keyboard data
output
A measurement data transfer device for Mitutoyo digimatic
tools.Digi-Std4 converts measurement data to PC RS232C
port (ASCII code), or USB
keyboard data to PC, Capability of connecting up four
different tools.
The measuring result can export to
Excel sheets, without staff key- in , will not happen
again artifical input errors, and cost savings. .......more
|
|
1 ch tool connection |
output BCD signal |
Mux-BCD1
data processor/ BCD output for PLC
A measurement data transfer device
for Mitutoyo digimatic output tools.Converts measurement
data to BCD(Binary Coded Decimal)
and output it to PLC......
more
|
|
1ch tool connection+FS. |
to PC USB port
|
DigiLink-USB/
the data convert into keyboard signal
The DigiLink-USB is an interface,
it converts the Mitutoyo digimatic instruments data
to be a keyboard signals and directly fill data to your
application software lik word, excel notepad .... by
PC USB port.
It is small and more easily to operation. You don't
need to setup any program and connects external power......
more
|
|
instruments RS232 connect |
to PC USB port |
RS232-USB/
the data convert into keyboard signal
The RS232-USB is an interface, it
converts the RS232 signal to be a keyboard signals (just
transfer value, not contain other distinguish signals.)
then directly sending to PC USB port and directly filling
your application program like word. excel, notepad ......
.
It is small and more easily to operation. You don't
need to setup any program and connects external power......
more
|
|
1ch tool connection |
output 4~20mA |
DigiLink-mA/
the data is convert into milliamps
DigiLink-mA convenience of operation, Connected to
a Mitutoyo digital output of the measuring tools, and
plug the +24 V power supply, it can be convert the tools
data directly into currents (output range 4~20 mA).
The analog signal can be sending to PLC controller become
the automation control systems source signal.......
more |
|
1ch tool connection |
output 0~10V |
DigiLink-V/
the data is convert into voltage
DigiLink-V convenience of operation, Connected to a
Mitutoyo digital output of the measuring tools, and
plug the +24 V power supply, it can be convert the tools
data directly into voltages (output range 0~10V).
The analog signal can be sending to PLC controller become
the automation control systems source signal.......
more
|
|
Lens calibration chart |
Calibration
chart
The lens magnification correction chart. |
|